Supercharger Pulley Upgrade Jaguar XFR XKR XJR Land Rover 5.0 Eaton TVS
Special Order | Special order |
---|
Upgrade of the upper pulley pulley for the Supercharger.
The upper pulley of the compressor / supercharger is replaced by this component. This increases the boost pressure. The result is an increase in performance and noticeably more torque. No further modifications work required.
Technical specifications
- Reduction by 8% - that is the maximum that is possible without converting the Supercharger
- Performance increase typically (without danger)
- Power 510 PS (375 KW) to 562 PS (414 kW)
- Torque from 625 Nm to 750 Nm
Suitable for the following vehicles
- Jaguar XKR X150 5.0
- Jaguar XJR X351 5.0
- Jaguar XFR X351 5.0
- Jaguar F-Type R 5.0
- Eaton Compressor TVS
Does not fit 3.0!
Fitting instructions:
The supercharger pulley replaces the pulley on the vehicle. It has to be picked up by the supercharger. This is usually achieved by warming up and carefully cutting open the old pulley.
The upgrade pulley should be heated up. It also helps to shrink the Supercharger's shaft by using cold spray or storing the SC in a cool place. The new pulley must then also be put on.
It is not necessary to make any changes to the housing of the Supercharger. There is also the option of performing a further upgrade in combination with the lower belt pulley. We are happy to help!
Safety instructions
We clearly point out that this is a tuning part for which there is no general operating permit (ABE) or a TÜV certificate. Installation is at your own risk. There is only liability in the amount of the purchase price and in the case of demonstrably defective goods. We would like to point out that the compressor should be dismantled for the conversion and should not remain in the vehicle, as there is an acute risk of fire in the vehicle due to the necessary heating of the compressor.
Delivery information for special oders or factory orders
This order or the article contains one or more spare parts, all of which are special order or factory orders. These are custom-made products or special orders for spare parts, services or the like. Articles that are subject to these conditions are marked as such in the webshop. Those parts that are subject to this category can neither be cancelled nor returned. The warranty and other statutory rights remain unaffected. A recall is only possible in exceptional cases if the parts have not yet been ordered from the supplier. If you made a mistake, we recommend that you contact us immediately!
Delivery times
In many cases, special orders and custom-made products are shipped within 5-10 working days. In some cases, however, this can take considerably longer. Information on delivery times, also by phone or email, are all estimates, a binding commitment cannot be derived!